 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| ME DISPLAYS SPECIFICATIONS FOR LCD MODULE CCM1610 MICRO ELECTRONICS CORPORATION 3375 Scott Blvd. Suite 222 Santa Clara CA 95054 Tel: 408-988-1101 Fax: 408-988-7626 Email: micro@microelect.com Http://www.microelect.com ME DISPLAYS * FEATURES Number of Characters Display Font Built-in Controller Input Data Power Supply Duty Cycle Options CCM1610 16 x 1 line Character 16 characters x 1 line 5 x 8 dots HD44780 or Comp 4 Bits or 8-Bits Interface +5 V Single Power 1/16 Duty EL/LED Backlight, TN/STN * MECHANICAL PARAMETERS Module Size Viewing Area Size Dot Size Dot Pitch 80.0W x 36.0H x 9.0 mm 64.5W x 13.8H mm 0.60 x 0.70 mm 0.65 x 0.75 mm * ABSOLUTE MAXIMUM Item Power Supply for Logic Power Supply for LCD Drive Input Voltage Operating Temperature Storage Temperature Symbol Vdd Vlcd Vi Ta Tstg Min. 0.9 0 Vss 0 -20 Max +7.0 13.5 Vdd +50 +70 Unit V V V C C * ELECTRICAL CHARACTERISTICS (Vdd=5.0V 5%, Ta=25C) Item Symbol Conditions Power Supply for Logic Vdd -Op. Voltage for LCD Vdd-Vo -Input "High" Voltage Vih -Input "Low" Voltage Vil -Output "High" Voltage Voh - Ioh = 0.2mA Output "Low" Voltage Vol Iol = 1.2mA Power Supply Current Idd Vdd = 5.0V Min 4.5 -2.2 -2.4 - Typ -5.0 ---1.0mA Max 5.5 Vdd 0.6 0.4 3.0 U V V V V V V mA Micro Electronics Corp Http://www.microelect.com ME DISPLAYS * PIN ASSIGNMENT Symbol Vss Vdd Vo RS R/W E DB0 DB1 DB2 DB3 DB4 DB5 DB6 DB7 Level ---H/L H/L H, HaL H/L H/L H/L H/L H/L H/L H/L H/L Pin Description Ground Supply Voltage for Logic LCD Contrast Adjust Register Select Read / Write Enable Data Bit 0 Data Bit 1 Data Bit 2 Data Bit 3 Data Bit 4 Data Bit 5 Data Bit 6 Data Bit 7 CCM1610 16 x 1 line Character No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 * Function 0V 5V By User H: Data, L: Instruction Code H: Data Read, L: Data Write Enable Signal 8-Bit Interface 8-Bit Interface 8-Bit Interface 8-Bit Interface 4 or 8-Bit Interface 4 or 8-Bit Interface 4 or 8-Bit Interface 4 or 8-Bit Interface BLOCK DIAGRAM Micro Electronics Corp Http://www.microelect.com * DIAGRAM CCM1610 * ENVIRONMENTAL CONDITIONS Item Ambient Temperature (Ta) Vibration Shock Corrosion Gas Operating Min Max 0C 50C -20C --70C Non-Operating Min Max -20C 70C -30C 80C 2G 50G Remarks Normal Temperature Type Extended Temperature Type G=9.8 m/s2 XYZ Directions 0.5G -3G -No Corrosion Gas * OPTICAL CHARACTERISTICS TN TYPE Item Viewing Angle Contrast Ratio Response Time (Rise) Response Time (Fall) Symbol 2-1 K tr tf Condition K=1.4 =25 =0 =25 =0 =25 =0 Min 20 ---Typ -3 200 200 Max --250 300 Unit Deg -ms ms STN TYPE Item Viewing Angle Contrast Ratio Response Time (Rise) Response Time (Fall) Symbol 2-1 K tr tf Condition K=1.4 =25 =0 =25 =0 =25 =0 Min 40 3 --- Typ --200 250 Max --300 350 Unit Deg -ms ms Micro Electronics Corp Http://www.microelect.com * BACKLIGHT CHARASTERISTICS EL BACKLIGHT Electrical Data Parameter Power Supply Wave Shape Frequency Efficiency Capacity Operating Current Optical Data Parameter Power Supply Luminous Intensity Emission Homogenity Useful Life Brightness Uniformity (Relative Humidity <80%) Description Up to max. 230 RMS Sinusoidal Up to max. 3 KHz (dvA/cd) 0.50 nF/cm2 160mA Description 110v 400Hz sinusoidal 69.3 cd/m2 resp 20.4fl Color Green/Blue 500nm x=0.173, y=0.407 5% Unlimited 1000h approx. 80% 5000h approx. 50% Micro Electronics Corp Http://www.microelect.com LED BACKLIGHT Characterisitcs Low Voltage Driving (DC) is available without invertor No noise occurrence Life : 20K Hours Item Symbol Conditions Power Dissipation Pmax -Forward Voltage Vf Type Reverse Voltage Vr min Ir=1400uA Average Forward Current If max Vf=4.4V Rating 1960 4.4 10 350 Unit mW V V mA * AC CHARACTERISTICS (Vdd=5V 10%, Vss=0V, Ta=25C) Write Mode (Writing data from Micom to KS070B) Item Symbol Enable Cycle Time TCYCE Enable Pulse Width High Level PW EH Enable Rise/Fall Time tEr, tEf Address Set-up Time RS, R/W to E tAS Address Hold Time tAH Data Set-up Time tDSW Data Hold Time (Writing) tH Data Hold Time (Reading) tDHR * Min 500 220 -40 10 60 10 10 Max --25 ------ Unit ns ns ns ns ns ns ns ns TIMING CHARACTERISTICS Micro Electronics Corp Http://www.microelect.com * CONTROL AND DISPLAY COMMAND RS R/W DB7 DB6 DB5 DB4 DB3 DB2 DB1 DB0 Command Display Clear Return Home Entry Mode Set Remark Cursor Moves to First Digit I/D: Set Cursor Move Direction H-Increase L-Decrease SH: Specifies Shift of Display H-Display is Shifted L-Display is Not Shifted D: Display (H-on, L-off) C: Cursor (H-on, L-off) B: Blinking (H-o, L-off) SC: (H-Display Shift, LCursor Move) R/L: (H-Right Shift, L-Left Shift) DL: (H-8 Bits Interface, L-4 Bits Interface) N: (H-2 Line Display, L-1 Line Display) F: (H-5 x 10 Dots, L-5 x7 Dots) CG RAM Data is Sent and Received After this Setting DD RAM Data is Sent and Received After this Setting BF: (H-Busy, L-Ready) -- Reads BF: Indicates Internal Operation is Being Performed. -- Read Address Counter Contents Write Data into DD or CG RAM Read Data from DD or CGRAM L L L L L L L L L L L L L L L L L L L L L L L H L H I/D H X SH Display On/Off Shift L L L L L L H D C B L L L L L H S/C R/L X X Set Function L L L L H DL N F X X Set CG RAM Address Set DD RAM Address Read Busy Flag & Address L L L L L H L H H CG RAM Address (corresponds to address) DD RAM Address BF Address Counter Used for Both DD & CG RAM Address Write Data Read Data H H L H Write Data Read Data |
Price & Availability of CCM1610
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |